Industrial Sprocket Manufacturers Introduce The Maintenance Sk

  • Industrial Sprocket Manufacturers introduced that the scrap of a plate chain can be judged from several aspects:

    First of all, we need to understand that the amount of wear paper allowed by the chain is limited, generally within 10%.

    Secondly, take a look at whether the twist of the main ring of the chain is very serious, usually if the twist angle is greater than 10, it can be judged that the chain is scrapped. The sling of the plate chain will crack and bend after a long time of use. Once the chain has problems, it will affect the production schedule.

    In order to avoid the rapid scrapping of the plate chain, what we need to do is to do a good job in daily maintenance and maintenance. How to do it?

    First of all, the sprocket can be installed on the shaft, so as to avoid the material strip from shaking and tilting greatly.

    Secondly, the same transmission component, which does not require a rotating shaft to rotate, needs to be kept on a horizontal plane.

    Then, observe the tightness of the plate chain. Too tight or too loose is inappropriate. If the chain is too loose, the chain will be disconnected, and too tight will increase the transmission power. Avoid mixed use of new and old chains to avoid impact and break the chain during use.

    Through the above introduction, Conveyor Chain Manufacturers hopes that you can simply refer to the content of this article in future use.