Led Street Light Housing Manufacturers Introduces The Installat

  •  

    Led Street Light Housing  Manufacturers introduces the installation requirements of lamps:

    1. The lamps and accessories should be complete, and there should be no defects such as mechanical damage, deformation, peeling paint and cracked lampshades.

    2. The bearing capacity of the fixture on the wall ceiling where the luminaire is installed should match the weight of the luminaire.

    3. The chandelier should be equipped with a wire box, and each wire box can only be equipped with one set of chandelier. The surface of the chandelier must be well insulated, there must be no joints, and the cross section of the wire must not be less than 0.4 square millimeters. The wiring in the wire box should take measures to prevent the end of the wire from being forced to cause the lamp to fall. Lamps weighing more than 1 kg should be equipped with a hanging chain. When the weight of the chandelier lamp exceeds 3 kg, it should be fixed by pre-embedded hooks or bolts. The light wire of the pendant chain lamp should not be subjected to tension, and the light wire should be braided together with the pendant chain.

    4. Ceiling lamps with incandescent lamps as light sources must not be directly installed on combustible components; bulbs must not be close to the lampshade; when the distance between the bulb and the insulating table is less than 5 mm, heat insulation measures should be taken between the bulb and the insulating table . The power of the incandescent lamp must not exceed the maximum power allowed by the lamp.

    5. When the fluorescent lamp is used as the light source, the ballast should be installed on the phase line, and there should be a shell on the lamp to prevent the lamp pin from falling off, and there should be a margin in the lamp box. The frame of the giant lamp is parallel to the decorative line of the ceiling. The frame should be close to the ceiling surface.

    6. The phase wire of the screw lamp cap should be connected to the terminal of the center contact, the neutral line should be connected to the screw terminal, and the insulating shell of the lamp cap should be intact, free from damage and leakage.

    7. The diameter of the hook for fixing the lantern should not be smaller than that of the lamp hook, and the minimum diameter of the lamp should not be less than 6 mm.


    Through the above introduction, High Quality Street Light Housing Manufacturers hopes that you can simply refer to the content of this article in future use.