Installation Steps For Hot-Selling Street Light Housing

  •  

    Generally speaking, Hot-Selling Street Light Housing wants to be able to achieve the same brightness. The lamp uses about 70% less electricity than ordinary light sources. So how should she install it correctly?

    1. Please do not scratch or bump each line during the installation of the lamp, so as not to cause short circuit and burn the lamp, and the power supply must not be shorted (positive and negative contact).

    2. Pay attention to the installation of each component, power controller and bracket, all screws should be tightened.

    3. When threading, be sure not to pinch the wire to the lamp pole connection. The wire connection should be firmly connected and wrapped with PVC tape.

    4. Do not use components that are not recommended by the manufacturer, otherwise it may cause damage or danger to the system.

    5. When installing the lamp head, if the driving power of the lamp head is not built-in, it is recommended to install it at the lamp pole wiring door (communicate with the manufacturer in advance).

    6. When installing the cable, it is recommended to install a fuse (fuse) at the wiring door of the lamp post. If necessary, the loss can be reduced.

    7. If the lamp post is installed near the transformer or the voltage is unstable, it is recommended to install a voltage stabilizer to avoid damage to the lamp head.

    The above content is organized and shared by LED Street Light Housing | Die-cast Aluminum Light Housing , welcome to enter the station to learn more.