High Quality Street Light Housing Factory Introduces The Use Re

  •  

    High Quality Street Light Housing Factory introduces how to use street lights correctly:

    1.Use corrugated cartons to pack the lamps during transportation to prevent the glass mask on the lamps from breaking during transportation.

    2.During use, the surface temperature of the lamp will gradually rise, and the temperature on the glass mask will be very high, so it should not be touched.

    3. When replacing the light source or LED lamp beads, try to use the same type of light source and LED lamp beads. If you need to change the type of power of the light source, you must replace the matching electrical appliances or constant current source. The lamp needs to be replaced when the power is too high.

    4. Outdoor lamps should meet the requirements of waterproof and dustproof, suitable for outdoor use.

    5.The wire in the pole is not less than 1.5 square meters.

    6.The lamp is parallel to the light pole, and the light pole is 90 degrees perpendicular to the road surface.

    7.The precautions for street lights also include that the LED constant current source should be installed in the maintenance port under the light pole as much as possible to facilitate maintenance and replacement.

    Through the above introduction, Led Street Light Housing Manufacturers hopes that you can simply refer to the content of this article in future use.