Stainless Steel Faucets Manufacturers Share The Knowledge Of Th

  • There is always a small problem in the kitchen faucet at home, and it takes a lot of trouble to find a master to repair. In fact, the maintenance of the kitchen faucet is very simple, but many people are difficult to get rid of the kitchen faucet. Today, the manufacturer of stainless steel faucets teaches you how to remove the kitchen faucet.

    Kitchen faucet disassembly preparation tool

    Tools: small wrench (pliers can be used if not), Phillips screwdriver, fruit knife, old towel;

    Material: faucet rubber ring pad or small porcelain piece (this package is 3 yuan, a total of 5 sets of parts);

    1. Turn off the sluice of the house, usually next to the water meter. Some washing dishes will have a small opening underneath, it is more convenient to use this small sluice;

    Let go of the remaining water in the faucet, put an old towel on the side, and take it out with the waterproof faucet.

    Use a fruit knife to gently pry open the protective sheet on the handle. This small piece is usually put on or glued with glue;

    2. The protective sheet is removed, and the thin and flat piece is like a button;

    3. Use a screwdriver to loosen the screws that secure the handle;

    4. Remove the handle. The handle is snapped over the longitudinal tooth pattern and can be directly pulled out with a little force;

    5. Unscrew with a small wrench or pliers to remove the shaft;

    6. This is the shaft that is removed. The red one is the rubber washer. It can be replaced. And my faucet was changed a year ago, the gasket changed or dripped, so I replaced the two small tiles under the apron. I also saw some hardware stores selling this entire reel (about 5 bucks).

    7. The small porcelain piece under the gasket, the visual inspection is intact, but if you put it on a new one, it will not leak, I don't understand why.

    8. The left side of the tile is placed underneath, and the right side of the pendulum is placed on the right side. As shown in the figure, the front and back sides must not be reversed, otherwise the water cannot be closed.

    Follow the original steps to install the parts back and open the water test.

    information about stainless steel faucets :