Stainless Steel Handmade Sink Manufacturers Explains How To Cle

  • When the sink is blocked, don't worry, you can try these two methods introduced by AFA Stainless Steel Handmade Sink Manufacturers .

    First, use natural plumbing agents

    1. Rinse the sink drain with a mixture of baking soda and vinegar. First rinse the sewer with a pot of boiling water. Then, mix 1 cup (240 ml) of boiling water with 1 cup (240 ml) of vinegar. Add 1/2 cup (120 ml) of baking soda to the solution of boiling water and vinegar, and air bubbles should be generated at this time. After allowing the mixture to stand in the sink for at least 1 hour, rinse the sink drain again with hot water. If this method does not work, it may be severely blocked. Try using a mechanical dredging method.

    2. Use a mixture of salt, baking soda and hot water. About 5 liters of hot water is poured into the sink, then 1/2 cup (64 g) of salt is poured into a measuring cup, and then mixed with 1/2 cup (64 g) baking soda. Pour the mixture slowly into the sewer. After standing for 10-20 minutes, rinse the drain pipe with hot water.

    3. Dishwashing liquid and hot water. When the kitchen sink is clogged, you may wish to pour a large amount (100 ml) of detergent and 5 liters of hot water into the sink. Since the quality of the detergent is heavier than water, it will cause a chemical reaction between the sink bottom and the blockage of grease, which The sink is unblocked. But this method is more suitable for preventing clogging. You can use this method regularly to clean the kitchen sink drain to prevent clogging.

    Second, use simple pipe dredger

    1. The simple pipe dredging is an elongated flexible steel cable wound on a winding shaft, which is connected to a crank handle. Before the introduction of electric pipe dredging machines, this was the best dredging tool for plumbers. You can buy augers up to 100 feet (30 meters) in length, while 25 feet (7.6 meters) is the standard choice. You buy a simple plumbing dredge from a hardware store or a store near a grocery market.

    2. Remove the U-bend connected to the drain of the sink. The U-bend has two functions: 1. Deodorization, 2. Preventing garbage from flowing into the main pipe causing more difficult to handle blockages. If it is a U-bend made of PVC, it is likely to be fixed together with a cylindrical threaded joint, which can be removed by loosening it counterclockwise by hand. If bolted, you need to turn it counterclockwise with a pipe wrench to remove it. After removing the U-bend, check whether it is blocked, and if not, proceed to the next step.

    3. Insert the simple pipe dredging spring into the pipe until it cannot be inserted, and then start to turn the handle clockwise to push the spring forward in the pipe. When you feel resistance to the spring, turn the handle counterclockwise and pull it back. Turn the handle clockwise again to push the spring forward until the pipe is cleared. This process requires some patience and repeated trial and error. After confirming that the pipeline is cleared, install the U-shaped pipe.

    information about Stainless Steel Handmade Sink Manufacturers : https://www.afastainlesskb.com/product/sink/handmade-sink/